VEPR-12 Scope Mount Dustcover Rail – CSS

Replacement dustcover rail for the Vepr12 shotgun.
Machined from solid billet aluminum and then hard coat anodized.
Made in the USA.

Allows you to easily replace the factory plastic coated cast rails that are normally canted to one side.
-Make sure firearm is unloaded.
-Punch out the hinge pin that attaches the dust cover.
-Drill out the 3 rivet heads centers with a 3/16″ bit until they pop off from the inside of the dustcover.
-Install new rail and start 3 screws.
(Long screw and washer are for the front hole)
-Drive in new hinge pin.
-Tighten screws once you have verified the rail is sitting straight.
(Red Loctite is recommended to secure screws)

Dust cover not included.